2 in 1 Guardrail Interchangeable Forming Line

Description:

The production flow of equipment

De-coiling — Feeding (take the sheet to the first station) — leveling ---- Punching one --- punching two --- punching three --- punching four ---  roll forming -—— hydraulic cut to length --- auto stacker

The structure of equipment

 1: de-coiler with coil car

• Single unrolling machine, one side can put material
• Adopt automatic hydraulic system
• Coil weight (Max):10000kg
• Inter diameter: 470mm-520mm
• Maximal out diameter:1800mm
• Oil cylinder dia:120mm  working pressure: 20mpa (=20Tons)
• Coil width (Max.):1000mm
• Working speed: 0-25m/min
• Power: 5.5KW
• Hydraulic power: 3kw
• De-coiler should be with Loop control and hold down
• Coil car: 10Tons
• the motor power of coil car: 3Kw
• Pressure: 12Mpa
• Sample photo for reference:

2, feeding, leveling

Main features of the machine:The leveling roller's mechanical property such as rigidity and roughness concentration of the surface are rising very much after hardening and tempering. It includes pinch roll and leveling roll. The pinch roll can adjust along. The leveling roll uses the whole structure. There are two adjusting point at the front and the end. It can form a certain banked angle to improve the leveling quality. The feeding port of the leveling machine has a pair of guide plain-barrelled roll and two pairs of guide vertical roll. The guide vertical roll can moves centered or moves at the same time. It is adjusted by hand wheel, so it is convenient to centered

1: feeding the sheet to the guide roller (it is adjustable by right and left).

2: feeding roller: diameter is 160mm, material is 40CR steel, HRC48-52.

3: Leveling roller: upper is 3 rollers, down is 4 stations(total is 7 stations), material is 40CR steel, HRC48-52.

4: diameter of leveling roller: 180mm

5: leveling power: 5.5KW

3, punching (around about willfully adjusts)

• using hydraulic punching four unit punching
• oil cylinder dia: 180mm
• working pressure:30mpa
• mould material: Cr12  quenched 58°-62°
• hydraulic power:7.5kw
• size: 1.5m long*1.1m wide*1.2m high

punching is control by PLC, punching the two waves profile and three waves profile, just need control the PLC. Not need change or adjust anything.

• sample photo for reference:

4: roll forming

• main motor power: 55kw
• station: adopt cast iron HT50
• Decelerating motor: BWD14-43-55KW, made in Shanghai or Changzhou
• Transmission: by gear box: 200*500(outside is cast iron, surface needed polish and paint. Inside is 60# forge and press metal)

• main shaft dia: 100mm   material: 45forge steel
• roller material: GCR15 quenched 58°-62°,chromed
• roll station:20stations

• One machine can produce three waves profile and two waves’ profile.
• when change profile only need to change the last three stations (18^th, 19^th, 20^th)
• For easy to change roller and not need to adjust roller. We will design the two waves roller adopt single shaft with rollers---it means when change three waves profile to two waves profile, just take off the last three stations with shaft, and install the other shaft which with 2 waves profile roller.

• 

   Mr. zhao
  
  Tel: 86-510-81153870
  

  Contact to this supplier